Page 1 of 1
unable to select values
Posted: Thu Apr 22, 2010 9:26 pm
by turbo-2nr
i noticed in the new beta v1.4.7 i cannot select values like in voltage/lambda conversion tables and gear comp, and i know the values can be changed because iv done it be for, any one have a clue
Posted: Thu Apr 22, 2010 9:29 pm
by locash
No problems on my end, can you describe the process you are going through?
Posted: Fri Apr 23, 2010 7:39 am
by turbo-2nr
i click on it and it dont work, its like locked out iv been using s300 for about 4 years and have never had this problem
Posted: Fri Apr 23, 2010 8:18 am
by locash
Post your calibration file.
Posted: Fri Apr 23, 2010 8:28 am
by Hondata
If you have just downloaded from the S300 then save the calibration to the hard drive and re-open. Otherwise give us a screenshot of where it is going wrong.
Posted: Fri Apr 23, 2010 12:18 pm
by turbo-2nr
i thought it was maybe because i downloaded from the ecu but i tryed opening another calibration and it still wont let me change it