Page 1 of 1
cant update/upload to ecu
Posted: Fri Apr 09, 2010 7:03 am
by skadaloz
like title says i cant update/upload any of the calibration for my motor to my s300....it keep poping up an error that says plz try updating again....any help would b great...and does the hondata s300 suppose to light up red all the time??
Posted: Fri Apr 09, 2010 10:11 am
by Spunkster
From Help, about, what verison of software are you using?
Posted: Fri Apr 09, 2010 10:41 am
by skadaloz
then newest version that i just download yesterdAY...i could datalog and download from the ecu but cant upload to the ecu
Posted: Fri Apr 09, 2010 3:30 pm
by Spunkster
you have not answered the question. what is the version number?
Posted: Sat Apr 10, 2010 2:18 pm
by skadaloz
my hondata is s300-7657
the smanager is version 1.4.50
Posted: Mon Apr 12, 2010 10:01 am
by Spunkster
Try going to File, New and load the very first calibration. then turn the key off and back on. Don't start the car but look at the light and see if it is still red or if it turns green.
Posted: Mon Apr 19, 2010 7:13 pm
by skadaloz
ive tried that and its still red...could it be that ive bought a bad s300(used and its installed into a p13 ecu)
Posted: Tue Apr 20, 2010 10:17 am
by Spunkster
You cannot use a P13. You must use one of the ECUs listed at
http://www.hondata.com/ecus.html
Posted: Sun May 02, 2010 7:34 pm
by skadaloz
ic ic...thats the way i bought it..........ill mod my p28 to b s300 ready
Posted: Sun May 02, 2010 7:53 pm
by skadaloz
ok i was wrong its in a p91 ecu never heard the ecu b4
Posted: Mon May 03, 2010 12:15 pm
by Spunkster
Try the S300 in a known good ECU that has been socketed for an s300.
Posted: Mon May 03, 2010 7:41 pm
by skadaloz
well i dont know anyone else around here that has one ready for s300 so ima have to buy the pins and solder it myself