Page 1 of 1
IAT & ECT Correction Display
Posted: Fri Mar 26, 2010 5:36 am
by VT-Doo
I can't seem to see what the current IAT/ECT Corrections are which are being applied to the map within Sensors or Display.
Am I missing something or doesn't it exist? It comes in handy with the S300.
Thanks,
Posted: Fri Mar 26, 2010 1:49 pm
by Spunkster
When datalogging look at the parameters. You will need to make sure that you go to Options, Settings, Display and enable the parameter table tracing.
Posted: Wed Nov 17, 2010 5:44 am
by VT-Doo
I can't seem to see where the corrections are.
In the S300 I'm using it great, but even looking at the "sensors" window in KManager there is no corrections being displayed for water or air temperature.
Can you please show me where it is, or at least a picture of it within KManager?
Cheers,
Ian
Posted: Wed Nov 17, 2010 10:23 am
by Spunkster
Corrections cannot be seen in the sensor list. You will have to look at your corrections in parameters and see how they are set.
Posted: Fri Nov 19, 2010 5:37 am
by VT-Doo
Why isn't this the same as in SManager?
Posted: Fri Nov 19, 2010 10:14 am
by Spunkster
Different ECU hardware and software . It is completely different and does not have these parameters in the data stream.