Hondata

hey guys am just searching for some info before i go dyno my car..

am new to s300 but not new to tuning.i have read the guide and played with the software a lil and understand almost all at first glance but i have still got a few basic questions as am no familiar using this ems..

first off..
whats the difference between low and high speed tables? at first glance i notice the low speed concentrates on rpm ranging 500-6000 while high is more or less 5000-9000rpm.. is this a switch over table when vtec engages? also, could i just set the high table while on the dyno or do i need to set both high and low tables for best performance?

second..

if am doing a tune on pump and another on race fuel do i use the secondary table to do my race fuel tune.if so is there a way to switch between tables without connecting to a laptop?

thanks

low speed tables are for the low profile on the cam and the high speed are for the high profile on the cam, the vtec point is the switchover.

Secondary tables can be used for tunign different fuel. Please read this: http://www.hondata.com/help/smanager/se ... =secondary