Page 1 of 1
K-Manager HP calculator
Posted: Thu Mar 11, 2010 10:05 am
by Mask
Hi, i would like to know if K-Manager has some way to calculate the power with the cal. or with the datalog or with any other thing.
Thanks
Re: K-Manager HP calculator
Posted: Fri Mar 12, 2010 4:45 am
by rikitaun
Mask wrote:Hi, i would like to know if K-Manager has some way to calculate the power with the cal. or with the datalog or with any other thing.
Thanks
+1
Good idea from new version of Kmanager.... :idea:
Posted: Fri Mar 12, 2010 7:24 am
by Mask
from a new version? so you think there isn't anything like that in this last version?
Posted: Sat Mar 13, 2010 8:53 am
by LK7R
RAZDYNO
http://chewies.net/~raz/tuning/razdyno/
There is also one more program, but can't remember now... you can find it on clubrsx forum - mentioned in the link above.
Posted: Mon Mar 15, 2010 5:32 am
by LK7R
Here is KDyno program that I mentioned.
Posted: Mon Mar 15, 2010 8:33 am
by Mask
thanks, i already try it, but it gives me a strange graph...and the only numbers i get is the rpm...not hp :( is this program like that or i'm using it wrong...?
Posted: Mon Mar 22, 2010 2:42 am
by LK7R
This software is used for street tuning. You do datalog from 0,10,20,30,40,50 deg. runs on the same road for Low Cam and High Cam. Then put the LC into software to see in which RPM you have most power on which cam and do the same with HC datalogs. This way you can tune your car without dyno. Accuracy is not highest, but you can tune your car with it pretty well.
The sofware calculates acceleration > where you have most power, but not exact numbers.
Dan
