Datalogged lambda not shown on the tables
Posted: Mon Feb 01, 2010 9:14 am
Since I've installed the OBX ITB's, my datalogging is a little strange.
Some parts of the table are not being filled with the lambda values.
As you can see, when I open the graphs, the values are being datalogged ok, but not shown at the tables.
The calibration is full TPS dependent. Ignore the crazy MAP signal, I only have vacuum reference of cylinders 1 & 4.
I'll post my calibration and the datalogging so you can see what is happening.
Thanks.
Some parts of the table are not being filled with the lambda values.
As you can see, when I open the graphs, the values are being datalogged ok, but not shown at the tables.
The calibration is full TPS dependent. Ignore the crazy MAP signal, I only have vacuum reference of cylinders 1 & 4.
I'll post my calibration and the datalogging so you can see what is happening.
Thanks.