Hondata

Flamesuit is on.

I cannot activate the "parameters" section of the SManager. For instance, I want to adjust my lower Vtec level to 4500rpm...but can't because the parameters section will not allow me to check boxes or input manual data.
What's going on here? Is there a box I need to check/uncheck to allow me to adjust paramters???

I read the trouble shooting stickies on this forum and my s300 is installed correctly.

Yes. I have seached this forum.
Help will be most appreciated.

You have to load the calibration you are using into the software.

Cool....

I have B18C5 built with a b16 head...

Do you recommend calibration file: stockusp72.skl

or ITR file???