Hondata

The computer is a p72 obd1, I have a lm-1 using analog 1 on d14 for the stock narrow band and analog 2 on d10 for the wideband. i disabled the eld in misc and both wires are cut not spliced. Everything is working properly and the two wideband readings match but im getting a (code 20 ELD) under engine codes the CEL is not on. Any Ideas to get rid of the code would be apretiated.

Have u tried resetting the ECU to clear the code report or it just persists no matter what u try?

If u cant clear the code with Smanager(i think u have to be live datalogging to clear codes) then try do it manually by de-powering the ECU, by either turning off the ignition & removing the backup fuse or simply unplugging the ECU or the battery.
Make sure u de-power the ECU for at least 10secs.

nevermind somhow it worked itself out.