no 50º cam angle with AFM calibration
Posted: Wed Dec 09, 2009 7:45 am
Hi hondata,
sorry for the many doubths but I think I am the only one tuning with maf (FN2 euro civic) and so only hondata can aswer this.
I notice that if I use a AFM cal and I set 50º cam angle (Hi cam) the max that the car goes is 47º and never goes to the 50º that I put in the hi cam table.
Don't know if this is a problem or it's normal, but with a MAP cal the car goes to 50º.
And one more questiom. I notice that the AFM force induction start calibration for the FN2 have the cam breack points are set at 0-15-30-40-50 (and not the 0-10-20-30-40 in the reflash). Can I copy all my setings in the my actual cal to this force induction start calibration and use it in my NA car? I was thinking of this to use this cam anglles breack points.
thanks in advance
sorry for the many doubths but I think I am the only one tuning with maf (FN2 euro civic) and so only hondata can aswer this.
I notice that if I use a AFM cal and I set 50º cam angle (Hi cam) the max that the car goes is 47º and never goes to the 50º that I put in the hi cam table.
Don't know if this is a problem or it's normal, but with a MAP cal the car goes to 50º.
And one more questiom. I notice that the AFM force induction start calibration for the FN2 have the cam breack points are set at 0-15-30-40-50 (and not the 0-10-20-30-40 in the reflash). Can I copy all my setings in the my actual cal to this force induction start calibration and use it in my NA car? I was thinking of this to use this cam anglles breack points.
thanks in advance