Hondata

I have my turbo kit mostly completed, and have decided to run the hondata S200 + boost for it. I'm going to be using a p06 ecu. My car, I think, has peak and hold injectors, with the resistor box (box in front of the drivers side strut tower, has the fins for cooling on it) so I am assuming I need peek and hold for my setup. I am looking into Holley injectors along with MSD, havent decided on that yet. I just need to make sure I order the correct injector for my setup. Thanks for the input. L8r all

hope that helps

If the P06 you're talking about is from an OBD-1 92-95 Civic DX, you'll have to run the P&H injectors with a resistor box. The P06 ECU normall uses saturated injectors and NO resistor pack.