Page 1 of 1
Knocking with Reflash
Posted: Wed Oct 14, 2009 1:52 pm
by Itsuki
Hi,
I uploaded a datalog with the Reflash GroupN for the Euro Civic FN2.
My mods are:
CAI, RRC, 70mm TB, TB spacer, decat and 2.5" exhaust.
It´s supposed that the reflash was optimal with this mods. Why are this knocks?
Thanks
Posted: Wed Oct 14, 2009 2:19 pm
by Spunkster
The flashpro is tunable to allow you to tune out any problems and to tune it on the dyno for maximum gains.
Posted: Thu Oct 15, 2009 7:06 am
by Itsuki
Spunkster wrote:The flashpro is tunable to allow you to tune out any problems and to tune it on the dyno for maximum gains.
Sure 8)
Posted: Sun Oct 18, 2009 2:10 am
by Nitro1018
So, reflash GroupN (FlashPro) can be used without problem? It's the same like Group N ECU?
Posted: Mon Oct 19, 2009 1:27 am
by tp
Safe to use...yes .... as a base map.
Never going to be optimum as every car is different and needs setting up for your car on a dyno for best gains and performance.
Posted: Mon Oct 26, 2009 1:52 am
by Nitro1018
tp wrote:Safe to use...yes .... as a base map.
Never going to be optimum as every car is different and needs setting up for your car on a dyno for best gains and performance.
Thank's for your reply, but does Group N calibration the same like Group N ECU?
I read in forums, Group N calibration from FlashPro is bad...