Hondata

Posted: **Sun Sep 20, 2009 11:07 pm**

Was wondering, since there was no tutorial for desktop computers.

How do you upload a new calibration map into my car using a desktop computer that is not close to the car?

How do you upload a calibration map onto the flashpro, and then disconnect it from the computer, and then go to the car and upload the new calibration?

Posted: **Mon Sep 21, 2009 8:03 am**

Upload from your computer to the FlashPro.

Take the FlashPro to the vehicle, plug it in, switch on the ignition, press Program button for 1 second.

Posted: **Mon Sep 28, 2009 6:56 am**

Got another question related to this. Just got my FlashPro today, but won't have access to a laptop...well, ever. Later in the week I will have access to a PC right next to a car stall, but until then I'm left with a 50ft gap between the car and computer. Is it possible to LOCK the FlashPro to my Civic using the same method? (Holding the Program button.)

Thanks!

Posted: **Mon Sep 28, 2009 10:37 am**

Plug the FlashPro in to the car with the key on for a few seconds, then take it back in to the computer and lock it to the ECU.

Posted: **Mon Sep 28, 2009 10:49 am**

Excellent! Thank you!

Hondata

How do you flash the ecu with a desktop?

How do you flash the ecu with a desktop?