Hondata

Hey.

I just got my Kpro and fitted.

I just put a K20 dyno map on it.

I have a K20A2 with an induction kit and DCsports manifold and 2 1/2" exhaust system.

Dose any one have a map for this or is there anything i can do?

Sorry if it's a total newbie question :?

load the rsx-k20a2-coldair calibration on and do a datalog and post it up.

hey cranny...how do feel about that cam timing dip just before VTEC on the low cam? in your opinion should that be smoothed out or left alone?

cranny wrote:load the rsx-k20a2-coldair calibration on and do a datalog and post it up.

Ok cheers.

I will try and do that.

on which map keto? sorry you lost me there , haha.

the k20a2 cold air kal. the cam timing drop off just before VTAK.

it does yes , but youl find alot of the maps do that. seems to be the efficient route overall. youl notice the cam timing right after it drops off to 25 reads 40 , to get the cam where it has to be once you cross over into vtec.

It's just a basic euro Type R dyno map i'v got on it at the moment.