Hondata

My issue w/ the new version has not even taking care of since last time I posted.

Tested and works correctly with 1.5.3.

Hondata wrote:Tested and works correctly with 1.5.3.

Very interesting, gonna try a back up laptop tommorrow.

Ok, we've found the problem - it is from Vista Virtualization.

The work around is to install a copy of SManager into a directory other than program files.

We will fix this shortly.

Hondata wrote:Ok, we've found the problem - it is from Vista Virtualization.

The work around is to install a copy of SManager into a directory other than program files.

We will fix this shortly.

Nice, Thanks for pursuing.

My main laptop I use was originally Vista, but upgraded to W7 ultimate 1+ years ago.

Thanks
G. Eng

Hondata wrote:Ok, we've found the problem - it is from Vista Virtualization.

The work around is to install a copy of SManager into a directory other than program files.

We will fix this shortly.

Great job!!! thank goodness you finally found the problem. I know I'm not going crazy lol.

im using windows 7 what do i have to do to fix the issue uninstall nd reinstall? and where?

sw-ef wrote:im using windows 7 what do i have to do to fix the issue uninstall nd reinstall? and where?

Uninstall Smanager, when you run the .exe again the default installation to C:\Program Files\SManager will show up, just browse and create a new folder elsewhere perhaps under Windows and install it there.

Thanks for the Overrun Fuel Cutoff (MAP) table. I have always had a problem with extremely low throttle inputs causing the DFCO to activate prematurely. After a slight adjustment I no longer have the issue. That and the other improvements made me very happy. :)

Can you guys review if parameter tracing is supposed to work on the Pressure Vs Duty table on the boost control tab. I could've sworn it used to work while reviewing a datalog or realtime, i see it highlighted at 25% but doesn't move anywhere The paramenter tracing does work for the boost x RPM x Gear table.

Thanks
G. Eng

Not sure when it was added, but THANK YOU for the copy/paste function that I noticed in the most recent Beta.

TheWickedOne1 wrote:Can you guys review if parameter tracing is supposed to work on the Pressure Vs Duty table on the boost control tab. I could've sworn it used to work while reviewing a datalog or realtime, i see it highlighted at 25% but doesn't move anywhere The paramenter tracing does work for the boost x RPM x Gear table.

Thanks
G. Eng

Spunkster/Hondata - Have you guys had the oppurtunity to look in to this ?

No, it is not supported

Any future plans to have this added?

It cannot show tracing because the target boost is not datalogged.