Hondata

EFICU wrote: Mon May 31, 2021 1:02 pm Gotcha. Movin' all around for work. That's pretty cool.

We're just tuning the 0* cam angle right now. So we move vtec up and down to make sure all the fuel tuning is done properly before and after vtec engagement. The final vtec point will be determined at the end depending on the fuel table values and feedback from you of course. With the stock cat pipe, it probably won't be lower than 4600 or so like it was before, but we'll see.

EFICU wrote: Mon May 31, 2021 3:54 pm Yeah we'll try to get it as low as possible for you, and we can test some engagement rpms. Sometimes the data in the fuel table isn't perfect, and as long as you like the feel at a certain rpm for vtec that's all that matters. The butt dyno is the most important thing in remote tuning in my opinion.

Okay. Now onto the 15* cam angle. Vtec is at 4500 on this one. Same driving and third gear pull as before.

MM082001.SD.V2.Rev03 (15Cam)(Vtec4500).fpcal

MM082001 wrote: Mon May 31, 2021 4:50 pm

EFICU wrote: Mon May 31, 2021 3:54 pm Yeah we'll try to get it as low as possible for you, and we can test some engagement rpms. Sometimes the data in the fuel table isn't perfect, and as long as you like the feel at a certain rpm for vtec that's all that matters. The butt dyno is the most important thing in remote tuning in my opinion.

Okay. Now onto the 15* cam angle. Vtec is at 4500 on this one. Same driving and third gear pull as before.

MM082001.SD.V2.Rev03 (15Cam)(Vtec4500).fpcal

EFICU wrote: Mon May 31, 2021 6:54 pm That was it...

Here is the 30* cam. Vtec at 4500 still, same datalog style.

MM082001.SD.V2.Rev04 (30Cam)(Vtec4500).fpcal

EFICU wrote: Mon May 31, 2021 8:01 pm Lookin' good...

Here is the next one, 40* cam, same datalog, same vtec. We're getting close. It might like a little more cam angle with all your mods now. We'll see.

MM082001.SD.V2.Rev05 (40Cam)(Vtec4500).fpcal

EFICU wrote: Mon May 31, 2021 9:16 pm Alright it looks pretty good. I went ahead and blended everything out. I put some 45* cam angle in it in the mid range in vtec to see if it likes it, it just might with your new mods. Vtec does again look happiest at 4600. Let's go with that for now and we can move it down once we get everything lined out and verify.

Give this one a drive and post up the datalog. Depending on how the 45* likes it or not, it might pull really good in the mid range, or it might not. I'll know more once we see the next datalog. Same driving, and a third gear WOT.

MM082001.SD.V2.Rev06.1 (Blended)(WOT45Test).fpcal