Re: FlashProManager v2.4.6 Beta
Posted: Mon Aug 01, 2016 1:08 pm
Ok, found that problem and will do a release to fix later today.Reflash tachometer progress indicator: This do not work on FN2!
Ok, found that problem and will do a release to fix later today.Reflash tachometer progress indicator: This do not work on FN2!
Then post the results of the troubleshooting on the previous page
Hondata, is this possible on a FN2?R-12914 wrote:In additional to the tachometer-upload indicator if we uploading a map, can you make a feature like this:
https://www.youtube.com/watch?v=jJ465JikHvc
I mean only a fast (faster as in the video) turn up and down the rev counter, the coolant temperature gauge and fuel gauge when the ignition switch on!
Many cars have this feature from factory like a gauge check up!
It would be nice if you could define an option here, where we could enable or disable this feature with a hook in the software!
Is that possible?
Thank you!
is there a value by ur launch disengage speed? Mine was on 0 and it did the same as what urs is doin i then set it to 3mph n boom it workedm1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.
Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
The set rpms to show with the "cancel" switch still works, but if i rev up the engine, it does not work like before!Hondata wrote:
Here's a test procedure to follow:
1. Set launch rpm to 3000 rpm. Set full throttle shift to 4000 rpm and 1% throttle. Upload.
...
4. Press the 'cancel' switch and confirm that the tach does nothing. Press in the clutch as well as the 'cancel' switch and confirm the tach shows 3000 rpm.
I'll try that too along with what hondata said with the test procedureGaryBar wrote:is there a value by ur launch disengage speed? Mine was on 0 and it did the same as what urs is doin i then set it to 3mph n boom it workedm1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.
Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
No probs hope u sortedm1ll3rlyt3 wrote:I'll try that too along with what hondata said with the test procedureGaryBar wrote:is there a value by ur launch disengage speed? Mine was on 0 and it did the same as what urs is doin i then set it to 3mph n boom it workedm1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.
Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
make sure you set the disengage speed to 3 mph or whatever above 0mph. I first did that and was like well the cruise buttons work but it would rev past whatever I set the launch at. and then realized I never changed the speed disengagem1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.
Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
This works fine, now on FN2!Hondata wrote:Ok, found that problem and will do a release to fix later today.Reflash tachometer progress indicator: This do not work on FN2!