Hondata

EFICU wrote: Sun May 15, 2022 4:17 pm Yeah but it looks like you're datalogging through your laptop, so you can't use that as a calculation for acceleration. The sample rate through the a laptop is lower than logging through the FlashPro. But it does look better.

Now that the cat is out it's really filled in that midrange. You're probably better off to run through the 30-40-45 cam angle again to build out the cam angle map again. Unless you're happy with how it feels, but I'm pretty sure there is some midrange missing based on how lean everything went on that one. Let me know if you want to run through them again and I will send the next revision based on that.

EFICU wrote: Sun May 15, 2022 4:52 pm Okay. Take this one for a spin, this will be the 30* cam with vtec at 4500. We'll just run through the 30-40-45 angles to build it out again.

MM082001.SD.V4.Rev52.1 (30Cam)(Vtec4500).fpcal

EFICU wrote: Sun May 15, 2022 7:27 pm Looks good. Here is the 40* cam.

MM082001.SD.V4.Rev53 (40Cam)(Vtec4500).fpcal

EFICU wrote: Sun May 15, 2022 8:08 pm Looks good. Here is the 45*.

MM082001.SD.V4.Rev54 (45Cam)(Vtec4500).fpcal

EFICU wrote: Sun May 15, 2022 8:52 pm Interestingly it liked almost all that 45* which is odd. Anyways, I blended it out a little bit. So take this one for a spin and see what you think.

MM082001.SD.V4.Rev55 (Blended)(Vtec4500).fpcal

EFICU wrote: Mon May 16, 2022 7:04 pm Looks good. Go ahead make another datalog when you can and we will see if it stays as consistent.

EFICU wrote: Tue May 17, 2022 8:13 pm Yeah it looks good for now. Once you get the clutch broken in and you're able to make some pulls we'll look over it again. The new stuff might change things a little bit, but nothing we can't touch up easily.

EFICU wrote: Tue May 17, 2022 8:13 pm Yeah it looks good for now. Once you get the clutch broken in and you're able to make some pulls we'll look over it again. The new stuff might change things a little bit, but nothing we can't touch up easily.