Hondata

warm idle and normal driving

Can you post the calibration file you are running. I used the Stock 2004 & 2005 TSX as a reference but its best to post the exact file you are running. It shows the car is running lean at idle.

- Ed

I’m running the stock TSX high octane kal. I’ll have to find it. I can start on a specific base if easier.

It’s up to you what map calibration file you want to run. You need to calibrate your TPS and then save the file. You can then post here with a datalog and I can check and make sure it’s running safe.

-Ed

That’s what I’m running now with the TPS calibration. I can try and calibrate again.

If it’s already calibrated just post the file. But again if you want to take advantage of the 50 Vtc you need to load a calibration file that is using the 50vtc or get a custom tune.

-Ed

50 VTC is not installed. That’s why I’m working off the TSX kal.

tlikethedrink wrote: Thu Jul 06, 2023 5:39 am 50 VTC is not installed. That’s why I’m working off the TSX kal.

Sounds good. Post the file when you get a chance.

-Ed

tlikethedrink wrote: Fri Jun 30, 2023 11:30 am warm idle and normal driving

This file not work?

tlikethedrink wrote: Thu Jul 06, 2023 6:34 am

tlikethedrink wrote: Fri Jun 30, 2023 11:30 am warm idle and normal driving

This file not work?

Yes, it’s fine. I told you my findings in one of my previous posts. I would need the calibration file to make minor adjustments.

If all you need was a datalog review then adjust the fuel idle.

-Ed

sorry for the misunderstanding. loading tune now.

I made a few minor fuel adjustments. Load the new file and create a normal drive datalog.

-Ed

heres a little snippet

Cleaned a few lean spots at part throttle. WOT fuel looks good.

-Ed

i hadnt been driving the car. ac went out again. had to order a replacement compressor. but i finally got it all done and back together.

let the car warm up and took it for a 15 min drive before this log. throttle cable/bracket needs work. so high idle and rev hang is in there.

also, while i had it all out, i cut the water port on the intake manifold and installed a bypass. also a thermal IM gasket. hopefully it helps with this heat wave!