Calibrations from 1.1.2.7 not compatible with 1.1.3.4?
Posted: Mon Jan 25, 2010 12:42 pm
I think there is a significant bug in the fuel mapping in 1.1.3.4 or the new firmware. I've attached a calibration file and associated datalogs that was created, flashed, and datalogged yesterday using 1.1.2.7 and the old firmware. I installed the new version of software this morning (1.1.3.4), which then installed the new firmware. Then I made a couple minor tweaks to the calibration, and flashed it, then datalogged it at lunch. My AF values were WAY OFF from yesterday.
Below VTEC, the AF values went really lean, and after VTEC, the AF values went really rich. Just to make sure that it wasn't due to a change I made in the calibration, I reloaded yesterday's calibration, reflashed, and datalogged it again. As I suspected, the AF values are still WAY OFF.
Are calibrations created in 1.1.2.7 not compatible with 1.1.3.4? Do I need to start over?
Serial Number is FP-S2K-US-30040
Below VTEC, the AF values went really lean, and after VTEC, the AF values went really rich. Just to make sure that it wasn't due to a change I made in the calibration, I reloaded yesterday's calibration, reflashed, and datalogged it again. As I suspected, the AF values are still WAY OFF.
Are calibrations created in 1.1.2.7 not compatible with 1.1.3.4? Do I need to start over?
Serial Number is FP-S2K-US-30040