Hondata

Posted: **Thu Jan 03, 2008 7:21 pm**

mike93hatch you cut em both and it now is a dead on match from your laptop to the actual reading of the wideband?
Plus what ecu are you using if i may ask, p28, etc.

Posted: **Thu Jan 03, 2008 10:52 pm**

DOHCAccord wrote:mike93hatch you cut em both and it now is a dead on match from your laptop to the actual reading of the wideband?
Plus what ecu are you using if i may ask, p28, etc.

that is correct... running a p28

Posted: **Mon Jan 07, 2008 3:04 am**

heres a good Question then... do HONDATA remove these two resisters from their HONDATA prepared ECUs ???? :idea: :?:

Posted: **Mon Jan 07, 2008 5:39 am**

OTT wrote:heres a good Question then... do HONDATA remove these two resisters from their HONDATA prepared ECUs ???? :idea: :?:

i would probably say no..

Posted: **Mon Jan 07, 2008 10:46 am**

These are not removed on any Hondata prepared ECUs.

Posted: **Tue Jan 08, 2008 10:30 am**

in this case I have a different related question...

when D10 ELD is being used for wide-band input and ELD is disabled....

1. will removing the two resistors affect normal operation of the ECU?

2. Do I need to install a jumper to replace each resistor or can I simply cut the resitor out?

Posted: **Tue Jan 08, 2008 12:38 pm**

You only have to cut them. It will not cause any problems.

Posted: **Sat Jan 12, 2008 4:09 am**

besides D10, what other methods can be used to connect the white wire of an AEM wideband to incoorporate it with the hondata s300?

Posted: **Sat Jan 12, 2008 8:18 am**

i just pop mine out and we'll see how it goes..................to be continue

Posted: **Sat Jan 12, 2008 10:11 am**

well im piss this damn thing...................well i took off the r136 and r138 and now my AFR is just showing 2.00 what the hell is going on someone help me!!!!!!!!!!!!!

Posted: **Wed Mar 05, 2008 9:52 am**

laziebun wrote:well im piss this damn thing...................well i took off the r136 and r138 and now my AFR is just showing 2.00 what the hell is going on someone help me!!!!!!!!!!!!!

Free bump! I want to know whats happened!!? your got this sorted now??

Posted: **Fri Mar 07, 2008 7:14 am**

me too, what happened?

Posted: **Sat Mar 08, 2008 9:23 am**

Hope you had cut the correct resistors on the exact location..coz I had cut mine and the AF values are dead on with the gauge and laptop.

Posted: **Wed Mar 26, 2008 3:27 pm**

Jdm ecus have the d10/eld active.

But no one can tel me what resistor i must remove.

If i connect wideband directly i have a bad reading, impossible to down under 1/1,5v

So i connect on the d14 but i really want to know what are the resistors we must remove on the JDM ecu to work :)

scuse for my bad english, i'm not english :p lol

Posted: **Wed Mar 26, 2008 4:25 pm**

There are no resistors that need to be removed on a JDM ecu.