Page 2 of 2
Posted: Sun Jun 10, 2007 5:57 pm
by scoobs187
I put the engine from the 88 Integra the B20 Vtec in the 95 Integra I built and I went for a quick drive. I dataloged this I just don?t know what im reading (what it means).
Posted: Wed Jun 20, 2007 4:23 pm
by jordancivic
Fueling looks good above 3500rpm FT, a little rich but nice flat line.
Are you still having det problems?
Hondata: on this datalog i have my MAP sensor set to PSI and im noticing that at idle he is reading 2/3psi. Is this just because PSI is positive pressure and wont show below around zero?
Posted: Wed Jun 20, 2007 4:28 pm
by jordancivic
Fueling looks good above 3500rpm FT, a little rich but nice flat line.
Are you still having det problems?
Hondata: on this datalog i have my MAP sensor set to PSI and im noticing that at idle he is reading 2/3psi. Is this just because PSI is positive pressure and wont show below around zero? When reading Mbar it reads fine, i know im missing something simple. Something to do with psi reads above atmospheric pressure or something? Thanks
Posted: Wed Jun 20, 2007 4:54 pm
by Spunkster
set to read "/psi
Posted: Sat Aug 18, 2007 3:15 am
by scoobs187
What is the max map you can set for the software
Posted: Mon Aug 20, 2007 10:00 am
by Spunkster
scoobs187 wrote:What is the max map you can set for the software
What do you mean?