Hondata

Posted: **Tue May 29, 2007 2:48 pm**

TurboLS wrote: and then adjust the offset in Hondata until they match.

Where in Hondata are you seeing the A/F ratio (besides when datalogging) I know where to adjust it, just dont know where to check it.

Posted: **Fri Jun 01, 2007 11:04 am**

found it, under sensors, change units from wideband to A/F

Posted: **Sat Jul 28, 2007 7:30 pm**

so should i run the cap?
or disable the o2 heater

Posted: **Mon Jul 30, 2007 10:07 am**

There is no cap. You can either disable the o2 heater or add a resistor to allow the ecu to think the heater is working.

Posted: **Mon Jul 30, 2007 7:09 pm**

oh ok.
but what about these caps i got.
should i run them or not.

plx with s300?