Page 2 of 2
Re: 05/06 RSX with k20a2
Posted: Thu May 16, 2024 10:44 am
by Kreetoes
Would I have to revert back to the A3 engine harness or would the car work with the A2 harness?
Re: 05/06 RSX with k20a2
Posted: Thu May 16, 2024 11:01 am
by Spunkster
The original engine harness should be used in the vehicle.
Re: 05/06 RSX with k20a2
Posted: Fri May 31, 2024 2:54 pm
by Kreetoes
So I got the ecu re-modified and am currently still only getting a crank.
Re: 05/06 RSX with k20a2
Posted: Fri May 31, 2024 3:22 pm
by Spunkster
Will it run on the original ECU?
Re: 05/06 RSX with k20a2
Posted: Fri May 31, 2024 5:06 pm
by Kreetoes
Yes, it runs on the original ecu
Re: 05/06 RSX with k20a2
Posted: Mon Jun 03, 2024 8:51 am
by Spunkster
Post the calibration you are uploading to the ECU.
Re: 05/06 RSX with k20a2
Posted: Wed Jun 05, 2024 1:15 pm
by Kreetoes
Here is the calibration as well as the datalog when i try to start it
Re: 05/06 RSX with k20a2
Posted: Wed Jun 05, 2024 1:42 pm
by Spunkster
You need to try the K-Pro ECU on a known working vehicle. To see if the ECU starts normally in that vehicle.
Re: 05/06 RSX with k20a2
Posted: Thu Jun 06, 2024 9:39 am
by Kreetoes
I tried the K-Pro in another vehicle and that car has started
Re: 05/06 RSX with k20a2
Posted: Thu Jun 06, 2024 9:45 am
by Spunkster
It is most likely a problem with the wiring in your vehicle.