Hondata

Is there a way to check if the board is getting power because even outside of the car the kpro won’t connect to laptop

Did you wire the VSS into the K-Pro board?

No I jumped the c101 pin 3 to ecu b11. I have a adapter on vss for css

B11 is not a vss input for the ECU.

So did I fry my board? I don’t smell anything or anything like that and my car still starts fine

I saw somewhere that it was a input for css conversion

undo whatever wiring changes you made and see if it works as it should. If it does not, you have probably damaged the K-Pro and or the ECU.

Okay I did do that and still nothing would I return to who I purchased from or contact hondata directly?

Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:

Name:
Address:
Phone:
Email:
Serial#:
Description of problem:

Include a link to this thread.

Okay I will do that now