Hondata

Saw a little more knockcount. Just letting you know its pretty hot and I had the AC on. I was able to fit my old exhaust with a high-flow cat as well. In case anything looks off.

I reduced the timing where knock was present. Load the new file and create a normal driving datalog with 3 WOT pulls.

-Ed

No knock events in the pulls. The three present very early on are in slow traffic.

Thanks

We are moving to VTC 30. Create a normal driving log. Once I confirm fuel is fine we can move to WOT. I noticed the car knocked in the last datalog due to you reving it to high. You should not rev the car past 7400. You rev'd the car up to 8300. I move up the rev limit so that the car doen't cut fuel.

-Ed

Updated log. Sorry, I wasn't paying attention to the RPM range as I was in the 7400 range at about 80mph so thats all I was looking at for the last log. I'll make sure to watch RPMs to be sure.

Create a normal driving log with a 3 WOT pulls.

-Ed

New logs. Idle felt funny initially, i checked for vacuum leaks or loose hose but didn't see any. Seemed to smooth out during the drive.

Cleaned up some of the fuel. Create a normal driving log with a WOT Pull. If all is well we will move to VTC 40.

-Ed

For your review. Thanks.

Create a normal driving log with a few wot pulls.

-Ed

Far less knock events. 5th gear moving in traffic feels much better with the latest revisions.I could only do 2 full WOT pulls. Last one was cut short. Thanks.

Finishing up the non Vtec side and blending the VTC tables. Create a normal driving log with a WOT Pull.

-Ed

Completed. Thanks.

Moving to the Vtec side VTC 0. Create a normal driving log.

-Ed

Sorry this log ended up being a little longer than normal. I ran into a ton of traffic and couldnt get to my computer to restart the log.