Page 2 of 2

Re: 2011 civic Si Basemap Help

Posted: Tue Nov 09, 2021 8:48 pm
by FG2.MATT
Oops I clicked the wrong file i guess. lol but awesome thats good to hear and im excited!! Do you think theres going to be any benifits from the header at the stage I am now? My next purchase will be the skunk2 Megapower RR exhaust at the end of this month if i can find one that is. Then soon after that a 3.5 inch hybrid cai.

Re: 2011 civic Si Basemap Help

Posted: Tue Nov 09, 2021 10:16 pm
by EFICU
Until we fine tune the cam angle map for your car with the mods it's hard to say how much you would notice. It would depend on your test pipe setup as well. The header is the biggest upgrade you can though because it will free up the most restriction the engine sees. Once you get all the mods you mention, the car will really wake up for sure.

That one looked really good. I made a couple adjustments for knock again, and a couple fuel changes. Nothing major though, it's looking good, just splitting hairs at this point while we try to remove the knock. Take this one for a run when you can.
FG2Matt.SD.Rev04 (Vtec4350).fpcal

Re: 2011 civic Si Basemap Help

Posted: Fri Nov 12, 2021 8:10 pm
by FG2.MATT
Alright that sounds good. Oh and the alpha header is a one piece ... header so i wont have the test pipe no more so ill just have the skunk2 header and stock exhaust with a muffler delete and stock intake with k&N filter for now. Im going to install tomorrow which is Saturday and ill record a datalog right after and send to you. And i should stay on the current tune you created correct?

Re: 2011 civic Si Basemap Help

Posted: Sat Nov 13, 2021 6:20 am
by EFICU
Sounds good. Yes run the same calibration and then I'll make some changes in the next one for the header based on the data from this next datalog.

Re: 2011 civic Si Basemap Help

Posted: Sat Nov 13, 2021 6:03 pm
by FG2.MATT
Alright heres the datalog with the Alpha header intalled.

Re: 2011 civic Si Basemap Help

Posted: Sun Nov 14, 2021 7:02 am
by EFICU
Overall it looked good after the header install. I made a few changes to the fueling and the ignition for some knock. Take this one for a spin when you can and we'll see how it looks.
FG2Matt.SD.Rev05 (Vtec4350).fpcal

Re: 2011 civic Si Basemap Help

Posted: Thu Nov 18, 2021 4:34 am
by FG2.MATT
Here's the next data log. Quick question idk if its just in my head and a error on my part with my shifting but i feel like recently when in vtec under like 6k rpm the car jerks pretty bad like there's a delay when I go to give it gas again. Idk if that could be seen from the data log or not but id thought id bring it up since I've never felt that before.

Re: 2011 civic Si Basemap Help

Posted: Tue Nov 23, 2021 12:23 am
by EFICU
Do you have any idea where in the datalog you felt the issue? It's a roughly 17 minute datalog, do you know what timestamp you would say you felt the issue?