Page 2 of 2
Re: New to flashpro and could use some help
Posted: Sat Jun 26, 2021 3:20 pm
by EFICU
All good. We'll get it sorted.
Re: New to flashpro and could use some help
Posted: Sun Jun 27, 2021 3:03 am
by Notfd2
Aplogies for the mixup, I was unable to find the original datalog so I remade it after work today.
Re: New to flashpro and could use some help
Posted: Sun Jun 27, 2021 9:45 am
by EFICU
No Problem, looks really good. I made a couple fuel changes to tighten things up. Take this one for a drive when you can. It's 99% there, I'm just nitpicking a couple small things now.
Notfd2.SD.Rev04 (Vtec4350)(CamAngles).fpcal
Re: New to flashpro and could use some help
Posted: Mon Jun 28, 2021 2:25 pm
by Notfd2
Didn't feel much different from the previous revision and everything looks ok on my end. Do you think it's ready?
Re: New to flashpro and could use some help
Posted: Mon Jun 28, 2021 3:33 pm
by EFICU
Yep, it's dead on now. I made one final revision with a cam angle adjustment and fuel at idle adjustment. Nothing you need to make a datalog for and nothing you would feel.
Enjoy it, if you need anything in the future let me know.
Notfd2.SD.Rev05 (Vtec4350)(Final).fpcal
Re: New to flashpro and could use some help
Posted: Mon Jun 28, 2021 3:58 pm
by Notfd2
Thanks so much for all your help!
Re: New to flashpro and could use some help
Posted: Sun Jul 18, 2021 7:51 am
by MorsusMihi
EFICU I havent seen you in just about a year,
Are you able to DM me please,