Hondata

This can be done in the closed loop section of the parameters window.

PLease can you be really basic and literally tell me which button to click, I am in closed loop parameters and cannot see anything that says enable closed loop.. Please help

Please see the help file: http://www.hondata.com/help/kmanager/cl ... losed+loop

Thanks for the link but thats not really answering my question

My closed loop parameters is set up using the wideband however as per my original post, it is running in open loop all the time

uncheck disabled (open loop) at the top. That will put it in closed loop using whatever method is also selected (built in or external).

Thats the problem, it's already not disabled... (the stock wideband is selected) but the whole log is fuel status 4 open loop

Post your calibration and a datalog showing the issue.

I posted them on another thread as I didnt want to take over the original poster's question, but I've put them below here

2003 DC5 JDM running the K20a-ITR basemap

I believe you were told not to use that calibration and to use a different one instead.