Hondata

like i said i took over some one elses project had to peace back together and i want to make it run good before i get new turbo on it

Yeah something isn't right. The cam angle commanded stays at 0 almost the entire time, even where the cam angle commended in the table is 30*. It does spike up once in a while but still not anywhere near the commanded angle in the table. Very strange. Also, you didn't make any changes to the calibration for your fuel injectors, so it's weird the fuel trims are as close as they are. There are a lot of things not following where they should honestly, commanded WOT lambda etc.

Not sure where to start you honestly, haha. I think the best course of action is to build a quick file for you to test. Are you able to take it for like a 10 minute drive once I put the file together just to test everything? I need to see if the cam angle will be correct, ignition, etc. Otherwise, something is wrong somewhere, perhaps the ECU. Let me know, basically need to send you a file that is much better done and test it to see if we get consistency.

yes i can

Okay, take this one for a quick 10 minute drive, nothing crazy, just smooth normal driving. Mainly looking to see if the cam angle follows properly and ignition follows. I put put it at 5* on the cam angle which would be a simple test for it.

This is a test file for Trippy only, do not use this under any circumstances if you aren't the OP of this thread.

ok ill be back

that one runs real rough i turned off did not drive

this is tune before turbo cam off

Interesting, I forgot to swap the file to a Hondata MAP sensor. Try this one now, if it runs the same as the other one then something mechanical is wrong somewhere I think. But let me know, there are a couple more options we can try. I also transferred the injector values from the original tune for test purpose. They are different from DW values slightly, but if the tuner tuned it with these values it might be the best bet.

Do not use this file unless you are the OP.

the datalog had the turbo tune on it

Were you able to try my second version, or no?

We can make changes to your tune if needed, it's just so poorly done it would take a lot of work.

i did try it was a lil rough stalled car runs on the turbo tune and drive just not best

Okay. Do you want the idle at 1000 still?

for now that is fine

Okay. Made some fuel changes to your file. Take this one for a drive and we'll see how the datalog looks. I moved vtec up to 5500 while we test the low cam stuff. On your drive, make a wide open throttle (WOT) pull from 3000-5000 in third gear too just so I can see how the WOT fueling looks there to make decisions on where to go from there.

ok that one ran better i dont know why but datalog in 3 parts let me know if i need to do another