Page 2 of 2
Re: cam command intermittent error
Posted: Mon May 24, 2021 10:17 am
by angelf1974
Check this. I found this problem in 2 customer´s cars
Re: cam command intermittent error
Posted: Mon Jun 07, 2021 1:47 am
by Undefined4door
angelf1974 wrote: Mon May 24, 2021 10:17 am
Check this. I found this problem in 2 customer´s cars
Interesting I took a quick glimpse at it while I had the valve cover off it looked fine i will look again though. Any chance it could be that oring on the timing cover thats causing some oil pressure issues? I installed a gauge although it fluctuates alot I'm getting anywhere between 25 to 55 psi at 3000 rpm and from 10 to 18 psi at idle
Re: cam command intermittent error
Posted: Tue Jun 08, 2021 8:44 am
by angelf1974
25 psi at 3000 rpm is too low
Re: cam command intermittent error
Posted: Fri Jul 09, 2021 1:45 pm
by Undefined4door
Just an update found main bearings wore down 😒 but swapped bearings out oil pressure good, looking at previous logs looks like I had some high knock counts at one point.
Re: cam command intermittent error
Posted: Tue Dec 05, 2023 8:36 am
by pablo345
IM HAVING THE SAME PROBLEM TOO REPLACED THE VTC GEAR AND VTC OIL PRESSURE ACTUATOR AND THE CODE STILL POP BACK UP RANDOMLY I HAVENT REPLACED THE VTEC SOLENOID AS YET BUT LOOKING TO DO THAT IF THATS THE PROBLEM ALSO IT WAS DOING THIS BEFORE I REPACE THE VTC GEAR AND ACTUATOR.