Hondata

Haha that makes sense for the idle issue then - i was under the impression Smanager could still control this idle rpm without the IAC, obviously not with your response.

Spunkster wrote: Fri Apr 26, 2019 4:59 pm Please describe the issue more clearly, as I do not understand.

Smanager-Parameters-Rev Limits-speed limiter

Under the above location there is a maximum rprm setting.

I have tried setting the rpm to something like 6000rpm to prove it works but it climbs way past this until i let off throttle

Grigg1 wrote: Sat Apr 27, 2019 1:39 am

Spunkster wrote: Fri Apr 26, 2019 4:59 pm Please describe the issue more clearly, as I do not understand.

Smanager-Parameters-Rev Limits-speed limiter

Under the above location there is a maximum rprm setting.

I have tried setting the rpm to something like 6000rpm to prove it works but it climbs way past this until i let off throttle

that is not the rev limiter. that is only used for the speed limiter.
the rev limiter is labelled rev limiter, at the top under that same tab.

Grigg1 wrote: Sat Apr 27, 2019 1:39 am
Smanager-Parameters-Rev Limits-speed limiter

Under the above location there is a maximum rprm setting.

But that setting is in SManager, which we already determined you shouldn't be playing with...

Notice how it's in the box clearly labeled "speed limiter". And the first of the 3 boxes is labeled "Rev Limiter".

Ok, let's recap what we learned!!

1) idle air control, controls idle

2) speed limiter, limits speed

3) Rev limiter, limits revs

4) alt+ F4 will close SManager and save your engine from damage.

BCMotors wrote: Sun Apr 28, 2019 7:07 am
4) alt+ F4 will close SManager and save your engine from damage.

HAHA! *thumbup*