Page 2 of 2
Re: CEL no hondata error code
Posted: Wed Apr 24, 2013 4:26 am
by Capone
Ecu looks good so does the wiring....
Re: CEL no hondata error code
Posted: Wed Apr 24, 2013 7:53 am
by Nazul
The irridium plugs have nothing to do with it, those are oem plugs and they work fine on my car
Re: CEL no hondata error code
Posted: Thu Sep 05, 2013 6:45 am
by Capone
I tryed the ecu in another car the same problem continues. One thing I did notice though was when the red light came on I picked up the ecu to plug it in and the red light turned to green. So any thoughts on what that is? I looked for connection problems again... Still found nothing.....
Re: CEL no hondata error code
Posted: Thu Sep 05, 2013 9:29 am
by Spunkster
Sounds like a cold solder joint. Post a picture that is close up and in focus of the solder joints.
Re: CEL no hondata error code
Posted: Fri Sep 06, 2013 9:36 pm
by Capone
ok there's some photos let me know if there good enough...
Re: CEL no hondata error code
Posted: Mon Sep 09, 2013 9:35 am
by Spunkster
In the second picture there is no solder AT ALL on the last pin on the right on the top row.
Re: CEL no hondata error code
Posted: Mon Sep 09, 2013 1:23 pm
by Capone
Damn I didn't even notice that.. I sent it in to you guys to get soldered because I was nervous to solder it my self. So I guess where do I go from here? Do I risk soldering it or send it back to you guys?
Re: CEL no hondata error code
Posted: Mon Sep 09, 2013 1:24 pm
by Spunkster
You can just solder this, that should fix it.