Page 2 of 3
Re: Closed loop not working
Posted: Thu Jul 12, 2012 9:12 am
by Spunkster
It just adjusts the short term fuel trim to get it close to whatever you have it set to in the settings. It does not do anything electrically.
Re: Closed loop not working
Posted: Thu Jul 12, 2012 11:59 am
by B18glaw
Can I adjust the settings on the short and long term fuel trim or do I need another map made up because this current map was done in the fall so it was colder
Re: Closed loop not working
Posted: Thu Jul 12, 2012 3:57 pm
by Spunkster
HAve you taken this to your tuner or asked them about this?
Re: Closed loop not working
Posted: Sat Jul 14, 2012 3:08 pm
by B18glaw
I had this problem when I first got my car tuned and it wasn't working properly. They suggest I conract hondata for answers
Re: Closed loop not working
Posted: Sun Jul 15, 2012 8:15 am
by B18glaw
what if i raised the short term fuel trim settings higher?
going to be calling during the week soo i can actually talk to some one
Re: Closed loop not working
Posted: Mon Jul 16, 2012 4:11 pm
by Spunkster
Re: Closed loop not working
Posted: Mon Jul 16, 2012 7:42 pm
by B18glaw
why post that link?
Re: Closed loop not working
Posted: Tue Jul 17, 2012 9:20 am
by Spunkster
becasue you still have not posted what it says to post
Re: Closed loop not working
Posted: Tue Jul 17, 2012 11:14 am
by B18glaw
We've been over everything and pretty much on the same page...do you work for hondata? Absolute worst service I've ever experienced...don't want a bad wrap of hondata going around do you?
Re: Closed loop not working
Posted: Tue Jul 17, 2012 11:19 am
by Spunkster
You have not posted the calibration or told us everything that has been done to the vehicle.
Re: Closed loop not working
Posted: Tue Jul 17, 2012 9:07 pm
by B18glaw
calibration
b18c with 84.5mm pistons
gt37r
1000cc dynamic injectors
skunk2 pro1 cams
hondata 4bar map sensor
68mm tb
Re: Closed loop not working
Posted: Wed Jul 18, 2012 9:58 am
by Spunkster
Can you also provide new datalogs showing the problem using the new version of software.
Re: Closed loop not working
Posted: Wed Jul 18, 2012 5:22 pm
by B18glaw
here i have proved 4 datalogs 20sec each... 2 at cold start and 2 at operating temp, both temps i logged open and closed
Re: Closed loop not working
Posted: Thu Jul 19, 2012 10:45 am
by Spunkster
What AEM wideband are you using? Have you tried a different input as suggested previously?
You appear to have some electrical issue as your battery voltage is vastly different between datalogs.
Re: Closed loop not working
Posted: Thu Jul 19, 2012 11:23 am
by B18glaw
Currently aem uego is connected and battery may have been slightly low when first started.
What kind of electrical issues would affect the input signal...a ground?