Hondata

Here is a datalog with me driving it, hopefully this will help you guys help me cause i am lost.

Post the calibration as well

so i took my car into a car repair place, they said the ecu should be sent to you guys to check it. is this possible?

You need to try the ECU in a known working vehicle. If it works propelry then it means there is a wiring fault or sensor problem in your vehicle.

You need to try the ECU in a known working vehicle. If it works propelry then it means there is a wiring fault or sensor problem in your vehicle.

i got a new ECU and the car runs now, will flood from running the 600cc injectors though. Now i need Kpro swapped over from the old ECU to the new one. how do i go about getting this done

Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:

Name:
Address:
Phone:
Email:
Serial#:

Include a link to this thread

do you have any advice on what sensor could cause this problem?? i sent the ecu in to you guys and you said it was good so thats not the problem. a new starting point would be great as this is my only vehicle.

Check your wiring as something you have done is not correct. Based on our conversation it sounds like you did something to the wiring at the throttle body and I have no idea why. You may have to take this to someone more familiar with wiring and have them go over everything.