Hondata

OK, I read several times this page and instructions, but still don't understand, sorry.

Moreover, What do I need to connect a wideband to a ELD?
ELD =PIN D10= Electrical load??

Is there the good setup on this?
What is the correct Voltage with a PLX?

Perhaps, I need to switch my wire from D14 Pin to D10 pin??

I re-checked yesterday and it seems to work now.

My wire were correctly connected to ELD PIN D10 but on S300 the AF (in options - Sensor) was in lambda unit not in Air fuel Ratio.

I needded to put 1,99 voltage Offset to read the correct value

Hope it helps someone else.