Page 2 of 3
Posted: Thu Dec 02, 2010 12:29 am
by burmese434
Ya it should. Just wondering on different compression
Posted: Tue Jan 11, 2011 8:40 pm
by ldbriggins
Hey Burmese I seem to be having problems with this basemap can you help I rebuilt the motor upgraded to Type r Cams when I crank it i get a carbon chokey smell garage is kinda blackish(not very dark).. timing is in sync this is the datalog I get when i crank it up.
Motor set-up
B18a1 81.5mm
9.0:1 piston
eagle rods
b18c1 head
type r cams
gt30 .70/.63
Lc-1 wideband
Posted: Wed Jan 12, 2011 12:01 am
by burmese434
call or text me and I'll help ya 614-390-4512 anytime
Check you cam timing, your vacuum looks alittle low. My setup is for 1000cc injectors. Put 1000 in the stock injector size and put 750 current injector size. Go to overall fuel trim and put that at 0. Start your car and see where your a/f is at. If it's still to rich put like -5 and so on till you get it to idol and take gas good. Is that a gt30r dbb turbo? If so your going to have to change the fuel curve because that turbo will start to spool quicker the the turbo on my setup so be very careful.
Posted: Wed Jan 12, 2011 12:20 am
by ldbriggins
Will do right now its 1:19Am(dark morning lol), so ill call you when i Get of later this morning.. :)
Posted: Wed Jan 12, 2011 12:28 am
by burmese434
ldbriggins wrote:Will do right now its 1:19Am(dark morning lol), so ill call you when i Get of later this morning.. :)
Sounds good If I dont answer just leave a voice mail and Ill call you back.
Posted: Wed Jan 12, 2011 4:23 pm
by ldbriggins
Fixed was a vacuum leak
Posted: Thu Jan 20, 2011 8:28 pm
by ldbriggins
heeres a short run
Posted: Sun Feb 06, 2011 2:26 pm
by ldbriggins
Heres my calibration & Datalog
car smells really rich at idle, but a/f looks fine at idle
Posted: Sun Feb 06, 2011 7:06 pm
by AREA876
Datalog shows TPS at 5% why is that?
Posted: Sun Feb 06, 2011 11:21 pm
by ldbriggins
I have no clue?
Posted: Mon Feb 07, 2011 5:15 am
by AREA876
Your TPS needs adjustment
Posted: Mon Mar 21, 2011 10:01 pm
by cutaoden
damn i tried to use your basemap on my setup and fucked shit up lol. iono what the problem is we have a similar setup, but now my car wont stay running. it starts up then dies.
did you figure out anything new on your map?
Posted: Tue Mar 22, 2011 4:24 pm
by ldbriggins
did you set all your parameters up? if so it should crank right on up... make sure you run this in open loop until you get tuned...
Posted: Wed Mar 23, 2011 1:16 pm
by cutaoden
yeah did set everything up but it could be the injector wiring or vaccum leak....got to figure that out first i guess.
Posted: Tue Mar 29, 2011 9:22 pm
by cutaoden
well it was running on all four cylinders on the old base map i had but i uploaded this one and now it wont run on all four cylinders. wonder why...