safety maps or default modes??

[aaron johnson]

S2000 Kpro 4 - (serial number not handy)

I've had this happen a couple times and i'm trying to figure out if there is a way to disable it or whether it's inherent to the ECU.

After a spin at high speed, if i keep the engine running which is optimal on track or if i stall it, i've had two of the following things happen
1) rpm won't go over 3500, this then goes away when power cycled on/off
2) car won''t refire until i cycle the power on/off

is there some sort of safety cycle which the ecu can go into based on forward/backwards quickly?
is there a chance when i cycle it that the map in the computer can get messed up?
the map in the computer should be set even of all power is removed (ecu removed) correct?

[Spunkster]

Are there error codes when this happens?

The ECU will not loose the tuning from power cycling it.

[aaron johnson]

no error codes have been thrown. it just seems to go into some sort of safe/limp mode.

[Spunkster]

It sounds like you will have to power cycle it if this happens as I am not aware of anything that would cause this.