can not get kpro 4 analog to read psi???
can not get kpro 4 analog to read psi???
Anyone here know how to get kpro 4 analog input to read PSI instead Voltage? I change the unit to PSI or bar and it still show Voltage. Oil pressure and fuel pressure is what I'm trying to do.
Re: can not get kpro 4 analog to read psi???
Can you post your calibration and datalog showing the issue?
Re: can not get kpro 4 analog to read psi???
Ok here is my calibrations and datalogs that I did. Let me know if I miss anything else.
You do not have the required permissions to view the files attached to this post.
Re: can not get kpro 4 analog to read psi???
so Spunkster, any ideas?Spunkster wrote: Tue May 08, 2018 10:30 am Can you post your calibration and datalog showing the issue?
Re: can not get kpro 4 analog to read psi???
They are showing readings. The conversion table you enter must be in BAR, then you can set the unit to PSI , then in the sensor window change them units for each input to psi as well with a reasonable min and max value.
Re: can not get kpro 4 analog to read psi???
WOW! change it to bar and it works. Thanks man.Spunkster wrote: Wed May 16, 2018 12:55 pm They are showing readings. The conversion table you enter must be in BAR, then you can set the unit to PSI , then in the sensor window change them units for each input to psi as well with a reasonable min and max value.