Fuel cut issue

[switchleg]

Hello,

I tried doing a pull tonight and the fuel cut out on my at 7300rpm. With the weather here being cold and the roads being icy I haven't had a chance to do many pulls in the high cam for a while though i believe this happened last week this same duty cycle and rpm. Looking at the datalog I cant see what could be the cause as my injectors were at 72% duty and pedal was at 101%. Any suggestions?

Also I have never experienced this issue in the past. I recently started using MAP to determine WOT and not sure if I have brought it to redline since.

[Hondata]

Disable full throttle shift and see if that is the cause.

[switchleg]

I haven't had time to test this but I am thinking this is the issue. I did have my foot resting on the clutch, maybe its a bit sensitive? Is there anyway to monitor the clutch sensor in flashpro?

[switchleg]

Also note full throttle shifting has been enabled since I first installed flashpro 2 months ago and only since had this issue in the last two weeks. I enabled determine WOT via map sensor 3 weeks ago and tuned the low cam but not the high cam yet.

[Hondata]

The clutch switch is just on/off, and does trigger with only light pressure on the clutch. I'd try disabling it and see if it is the problem.