Bluetooth connection and check engine

s300 and SManager software questions & answers
Post Reply
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Bluetooth connection and check engine

Post by Turbojoe »

Hello all need help just tuned car with s300 drove fine a few days check engine light came on then car died car started back up gave it gas but it died again seemed as i gave it gas it would like flood itself out usually the light wud flash then stay off after start up im trying to connect to the ecu threw the mobile app on android on bluetooth not working
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Bluetooth connection and check engine

Post by Spunkster »

Have you tried connecting using the laptop and SManager via USB to check the error?
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

I dont have a laptop was tryna go threw bluetooth because light wud blick then go off after start up now its solid b4 the car died idle was kinda low i just tuned dont know wats goin on and tuner not givin me to much info bout wat to do
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Bluetooth connection and check engine

Post by Spunkster »

You need to borrow a laptop to datalog properly and see if there are any errors. You may also need to setup the Bluetooth properly using the laptop.
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

Ill check wit a friend to see if i can borrow a laptop cud i jus take out the ecu n check it on my house computer
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

Ok i finally got the car to start the engine light is blinking 1 long time then a 2nd long time then 3 quick ones and its running like shyt i really dont even wanna drive it shud i get a retune and my idle is low
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Bluetooth connection and check engine

Post by Spunkster »

https://www.hondata.com/tech-ecu-problem-codes

It sounds like you need to get properly tuned on the dyno.
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

Just got tune and hondata
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

I had a chipped ecu then went with hondata will me driving the car with that knock sensor code mess up my car my set up is ls/vtec turbo or cud i go on the app and take it off or sumthin
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Bluetooth connection and check engine

Post by Spunkster »

You cannot make any changes with the mobile app. You must use SManager to tune or make any changes.
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

Is it safe to drive it to the tuner its prob 50miles or so
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

I have a laptop now
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Bluetooth connection and check engine

Post by Spunkster »

YOu should discuss this with your tuner as they will be able to look at your datalogs and tell you if it is safe or not.
Turbojoe
Posts: 9
Joined: Sun Jun 25, 2017 2:33 pm

Re: Bluetooth connection and check engine

Post by Turbojoe »

Ok so its the over heating safety or sumthin my tuner says he said that if i drive it to long it will throw the check engine light then shut down the motor
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Bluetooth connection and check engine

Post by Spunkster »

Have you datalogged to see what the exact error code is?
Post Reply