i dont know how to read datalogs
i dont know how to read datalogs
i did a few quick burst runs on 9psi, could anyone tell me if they see anything wrong? i do not know how to read datalogs
You do not have the required permissions to view the files attached to this post.
Re: i dont know how to read datalogs
Do you have a boosted engine without a intercooler?
What Map-Sensor do you have build-in?
FPM shows me a maximum boost of 1,52 bar / 22 PSI!
In part throttle, you must do a little bit fine tuning, to reach a s.trim vs. afm.c +/-5 (optimal).
In WOT your Engine runs a little bit too rich.
But it is always more useful to post your calibration, too!
What Map-Sensor do you have build-in?
FPM shows me a maximum boost of 1,52 bar / 22 PSI!
In part throttle, you must do a little bit fine tuning, to reach a s.trim vs. afm.c +/-5 (optimal).
In WOT your Engine runs a little bit too rich.
But it is always more useful to post your calibration, too!
2008 Honda Civic TypeR FN2
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E02
Flashpro: FP-SI-INT-21153
Software: 3.6.1.0
Firmware: 185
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E02
Flashpro: FP-SI-INT-21153
Software: 3.6.1.0
Firmware: 185
Re: i dont know how to read datalogs
yea its a 2017 honda civic hatch 1.5 turbo cvt.i have and aftermarket intercooler and 2.5 pipe,and intake.stock map
i attached the map i ran for a day
i attached the map i ran for a day
You do not have the required permissions to view the files attached to this post.