B16Turbo... Smanager not active Upload, Dataloging buttons

[lehabaev]

Hi all, i have b16a1 and P29 + Hondata S300.

Previously, everything worked well. But now driver installed, connection online but buttons Upload and Datalog is not active.
Please see screen shot.

Screen Shot 2017-03-11 at 11.36.06.png

Need help...

[Spunkster]

What is the serial number that is on the s300 board inside the ECU?

From Help, About, what is the version of software you are using?

[Hondata]

Is the vehicle ignition on?

[lehabaev]

Yes, ignition on.

This serial number?

Screen Shot 2017-03-11 at 11.35.59.png

[Spunkster]

From Help, About, what is the version of software you are using?

[lehabaev]

Software was updated around 1 a week ago.
Version 2.5.5.0

[Hondata]

The S300 is not seeing that the ECU is powered on. Check the S300 is seated correctly in the ECU, then start checking the main relay and fuses.

[lehabaev]

Can i check work state on the S300 (green light, red light etc..) ?

[Spunkster]

Also check to make sure that there is nothing leaking from any of the capacitors on the ECU. There is a very high possibility that the capacitors are going bad and need to be replaced.

We offer a replacement kit for this: https://www.hondata.com/products/access ... acitor-kit

[lehabaev]

Also check to make sure that there is nothing leaking from any of the capacitors on the ECU. There is a very high possibility that the capacitors are going bad and need to be replaced.

We offer a replacement kit for this: https://www.hondata.com/products/access ... acitor-kit

Leaked capacitors looks like that?

IMG_4659.JPG

[Spunkster]

They are over 20 years old, I would highly recommend that you replace them just to be safe.

[lehabaev]

I replaced C21 and C24 capacitors, but nothing changed.

When i connect PC to S300 (without ignition) SManager show online status.
When i turn on ignition, nothing not change.

Do you have any other ideas?

[lehabaev]

I recorded video with my problem. When you listen beep-beep it's i turn on ignition..

https://youtu.be/dbVI-czqScs

[Hondata]

It is not getting power through the ECU.

[lehabaev]

not getting power through the ECU.

Which S300 pin getting power? How i can check this?

Please see this image(with lamps); How should the lamps light up?

s300v3-500x500_jpg__500×500_.png