P08-020 AUZ HELP!! :(

EGHATCH · Post by **EGHATCH** » Tue Jul 12, 2005 8:14 pm

has anyone here tried this ecu? when i opened the ecu, it came with a factory external EPROM (with gold sticker). then i rechipped it, installed the IC socket and a crome bin...in ignition, the CEL goes away, so i start the car, after about 2-3 minutes, SOLID CEL comes in!!! wtf is that about...i thought it was checksum or something since crome had issues with that, so i installed my hondata s200....same thing, after 2-3 minutes, CEL goes in and runs in limp mode...

all of our P08 ARJ/ARH are working perfectly, it was my first time to see an AUZ

Post by **Spunkster** » Wed Jul 13, 2005 9:26 am

IS the interface box flashing or solid? WHat is the error code when datalogging?

EGHATCH · Post by **EGHATCH** » Wed Jul 13, 2005 11:36 am

i thought you can't datalog with Solid CEL. i'll try it later...

red light is flashing...when CEL comes in, it goes into limp mode..this ecu is driving me nuts

Post by **Spunkster** » Wed Jul 13, 2005 3:05 pm

If the interface box is flashing there is a prblem with either the Rom image or the socketing of the ecu. You will not be able to datalog unless the interface box is solid.

EGHATCH · Post by **EGHATCH** » Thu Jul 14, 2005 5:32 am

yeah, that's what i've read....i traced all connections and it seems to be okay...that's what keeps bothering me, CEL goes out in ignition, but when you start the car, after 1 min, CEL goes in..SOLID CEL and runs in limp. ?!

Post by **Spunkster** » Thu Jul 14, 2005 9:11 am

If the interface box is flashing, then you have the wrong rom image.

RMS · Post by **RMS** » Thu Jul 14, 2005 8:35 pm

can you post a pic of the bottom of the ecu (cover removed)? we do a lot of p08s. also, does it mil with the jumper removed?