smooth 2D lines or constant AFR
-
janiscrulzz
- Posts: 4
- Joined: Sat Dec 17, 2016 1:22 am
smooth 2D lines or constant AFR
i tune fuel in kpro. 2D lines looks bumpy but afr is 14,7 in part throttle and 12.8-13;1 wot. do i need to make 2D lines smooth or most important is AFR?
Re: smooth 2D lines or constant AFR
They should not be jagged. You can go through and artistically smooth them out.
-
janiscrulzz
- Posts: 4
- Joined: Sat Dec 17, 2016 1:22 am
Re: smooth 2D lines or constant AFR
When I smoot them out I take a look at datalog the AFR line is jagged. Whats better smooth 2d fuel lines or smooth AFR line?
In 2D map lines did not cross each other.
In 2D map lines did not cross each other.
Re: smooth 2D lines or constant AFR
When done properly you should have both smooth lines and smooth AF ratio. Post your calibration.
-
janiscrulzz
- Posts: 4
- Joined: Sat Dec 17, 2016 1:22 am
Re: smooth 2D lines or constant AFR
Please take a look at low cam 2D fuel lines.
You do not have the required permissions to view the files attached to this post.
Re: smooth 2D lines or constant AFR
That looks ok