PRA wideband Install?

[JackSVM]

Hi I'm new to this forum, Iv nearly finished my boosted k20 ep3.
I'm wondering can I use my AEM wideband lambda and wire it into the ecu ?
The car will be used/modified/raced/data logged regularly so I need to know my af's are sweet.
Thanks
Jack

[JackSVM]

Iv got Kpro on my PRA ecu btw.

[Hondata]

What KPro do you have?

[JackSVM]

Kpro4

[Spunkster]

Wire it into the analog or digital inputs to run closed loop form it that way.

http://www.hondata.com/help/kmanager/cl ... b=wideband
http://www.hondata.com/help/kmanager/an ... b=wideband
http://www.hondata.com/help/kmanager/di ... ub=digital
http://www.hondata.com/help/kmanager/di ... ub=digital

[JackSVM]

Sweet !
That's exactly what I was hoping for.
I can also wire my other AEM sensors in This way aswell then can't I? (Oil pressure/temp and water temp)

[Spunkster]

correct

[aaron johnson]

Ok. So I'm new to the kpro and in fact to computerised cars.


I've got an s2000 which I've fit a kpro4 to which I'm running in scca e production.

I have an aim evo4 data logger hooked up to the digital inputs using the can wires. I'm looking to switch from the stock o2 sensors to a plx dm-6 wide band o2 to run in closed loop configuration. Which wires in the digits input do I use to wire the plx to on the kpro to do this.

Thanks
Aaron

[Spunkster]

Have you read the links above?

[aaron johnson]

If I'm reading correctly I would wire to the purple serial wire.

Do you have suggestions for grounding? Should everything should be grounded to the same point?

[Spunkster]

Correct, you will probably not need to us any ground for the signal. Just the switched power and ground for the controller to work.