My calibration looks good and stayed between 11 to 11.8 AFR.
However, I can't figure why it bogged down at around 4,300 rpm.
WE tried everything but always bog at the same area.
Can someone tell me what's happening and clean my calibration?
Oh...it's Honda k2oz3 engine
Thank you
Pls. Clean my bogged @ 4,300 rpm
-
NuclearAtom
- Posts: 5
- Joined: Wed Oct 19, 2016 4:56 pm
Pls. Clean my bogged @ 4,300 rpm
You do not have the required permissions to view the files attached to this post.
-
NuclearAtom
- Posts: 5
- Joined: Wed Oct 19, 2016 4:56 pm
Re: Pls. Clean my bogged @ 4,300 rpm
Here is my Map
You do not have the required permissions to view the files attached to this post.
Re: Pls. Clean my bogged @ 4,300 rpm
It may not be tuning - 4500 rpm is very typical for intake system resonance, which usually produces a dip and then peak around that rpm.
Having said that, it is right at VTEC when the cam is rolling forward. Also there is a large jump in ignition from low to high cam.
Did you try VTEC higher and then then lower to see what the best torque curves for each cam were?
Having said that, it is right at VTEC when the cam is rolling forward. Also there is a large jump in ignition from low to high cam.
Did you try VTEC higher and then then lower to see what the best torque curves for each cam were?
Hondata
Re: Pls. Clean my bogged @ 4,300 rpm
Is the VTC working fine?, do you have a datalog to help you?