KManager serial output function enable

[amoras10]

Hello,

I have PRB ECU with hondata v4, latest Kmanager software.

Problem 1:
I was trying to connect external dash on serial outputs, i have also found in hondata help:
https://www.hondata.com/help/kmanager/i ... output.htm

Software Setting
• In KManager under Parameters, Multiplexer select the 'Datalogger Output' option.

There is no such option like Datalogger, there is two only: normal, disable.

Any solution>?

Problem 2:
Packet Description,
Is there any possibility to get fuel level packets, what is the bytes sum (asking because software has such displays).


Thanks for support and help.

[Spunkster]

What dash are you trying to connect?

[amoras10]

its a custom made display.
And we have prepared it to recive through serial output.

But how to enable in hondata serial outpout?
as described in hondata help it doest work, no such fuction in table.

[fonzeka]

Are you using a PRB calibration?

[amoras10]

yes im using PRB

[Spunkster]

With a K-Pro 4 you should be using the digital outputs, not the multiplexor output.

Details can be found at:
http://www.hondata.com/help/kmanager/di ... sub=serial
http://www.hondata.com/help/kmanager/ai ... sub=serial
http://www.hondata.com/help/kmanager/mo ... htsub=dash
http://www.hondata.com/help/kmanager/ra ... htsub=dash

[Hondata]

There are two ways to do this. You can use the ECU multiplexer output, which is a serial stream ('Multiplexer, Datalogger (xxxx bps)'). Or you can use the KPro4 serial output (RS232 or TTL level) - 'Digital Output' on the multiplexer screen. I'd use the KPro4 output.