Aim MXL set up

[radave]

Hi ,having probelms communicating with aim MXL via Aim convertor .The ecu is running 4.2.6 software which doesnt match the instructions supplied with the Aim convertor

Thanks Dave

[Spunkster]

What is the serial number of the K-Pro board inside the ECU?

[radave]

Hi ,thanks for the reply .The serial number is 15089
Dave

[Spunkster]

Only the K-Pro 4 can send the signal needed for the AIM dash. I am not aware of any converter from AIM to make this work with older K-Pros.

[Hondata]

The older KPros can drive the MXL using the ECU multiplexer output and the AIM adapter X05EFIHKPRO.
In KManager set the multiplexer output to 'datalogger 9600 bps', then wire the AIM adapter to the SEMFJ pin.
There is some outdated information in the AIM instructions which tell you to edit the KManager.ini file, which you don't need to do.

[radave]

thanks for the info ,but the only option in the multiplexer box is disable or enable no option "datalogger 9600 bps"

Dave

[Hondata]

What software version are you using?