Car stalling if I give it gas

[1989 crx si]

So today I was messing around with my car, I wanted to turn on my launch control. After I did my car started to idle awkwardly, then it was fine. But when I barely gave it some gas it would stall. If I stepped on it it would hesitate from 1000-2000 rpm but after it would hit the Rev limiter just fine. I turned launch control off but it would still die if u gave it any gas. Is there anything I did wrong?, how do I fix this?, have you guys had the same problem? I need help ASAP!!!

Thanks for your time

[Spunkster]

Try closing the program, reopen, load your calibration and re-upload to the ECU.

[1989 crx si]

Ok I'll try it

[1989 crx si]

Nope, I think it is running lean, my setup is a b18c5 with toda stage two cams, full exhaust, intake, intake manifold, throttle body. Does anybody have a calibration similar to this or what else can I do?

[1989 crx si]

Something else I forgot to mention, I have just recently bought the car and I don't have the original calibration they tuned it with