i have a 2008 civic si coupe
my current mods are
-pwjdm power chamber intake
-full race 3" cat back
-skunk 2 composite fuel rail
-hondata 4 bar map sensor
if anybody could help me with a calibration or have something similar, i would greatly appreciate.
thanks
Any calibrations similar to my bolt ons?
Re: Any calibrations similar to my bolt ons?
No - but why you install a 4 bar map sensor?
You have a natural aspirated system or not?
High MAP pressures gains with forced induction kit's only.
I have a rotrex kit inside and if cold outside I make 1.84 bar@8600rpm at maximum.
My kit is intercooled so the compressed air is cold before the air hits the engine.
You can easly use a start map for your mods and tune vtc, fueling and ignition.
You have a natural aspirated system or not?
High MAP pressures gains with forced induction kit's only.
I have a rotrex kit inside and if cold outside I make 1.84 bar@8600rpm at maximum.
My kit is intercooled so the compressed air is cold before the air hits the engine.
You can easly use a start map for your mods and tune vtc, fueling and ignition.